EMTRON KV16M

$4,797.00

Quantity
  • Product Description

      EMTRON KV16M

      “Our motorsport wire-in ECU Series is built on the race proven KV16 ECU platform with additional flexibility and reliability through utilising 136 Way Deutsch Autosport Connector System”

      Emtron’s KV16M is a wire in ECU with extreme flexibility.  Industry leading I/O count will ensure you do not have to make any sacrifices when configuring your engine and vehicle.  This ECU will support up to 16 Channels of Fuel (8 cylinders fully sequential staged injection) and 12 Channels fully sequential Ignition.  Every KV16M is housed in a durable billet Aluminium enclosure and includes up to 64Mb permanent memory for on board logging and oscilloscope function, DBW control, twin Lambda controllers, twin digital Knock control, Ethernet communications and 3 axis G-force sensing to name a few.

       

       

      1.0 General


      Power Supply

      Operating Voltage: 6.0 to 22.0 Volts DC (ECU shutdowns at 24.0V)
      Operating Current: 440mA at 14.0V (excluding sensor and load currents)
      Reverse Battery Protection via External Fuse
      “Smart” Battery Transient Protection
      Operating Temperature

      ECU Internal Temperature
      Max Operating Range: -30 to 110°C (-22 to 230°F)
      Recommended Operating Range: -30 to 85°C (-22 to 185°F)
      Physical

      6061 grade aluminum CNC billet enclosure
      Enclosure size 134 mm x 162 mm x 27 mm
      Weight: 750g
      Waterproof
      Connector system: 136 way waterproof connectors with gold plated contacts
      1 x 55 Way Deutsch Autosport (Red)
      1 x 26 Way Deutsch Autosport (Red)
      1 x 55 Way Deutsch Autosport (Yellow)
      Internal

      Dual 100MHz Processors
      500Mb DDR RAM (0.5Gb)
      32MB ECU logging Memory
      Over 1200 channels available
      1Hz to 500Hz logging rate
      6 channel Oscilloscope function
      Sampling at 100k samples/second
      Includes Crank and Cam sensors inputs
      Includes Digital Inputs 1-8
      3-Axis Accelerometer
      16 Bit Resolution
      +2g/+4g/+8g dynamically selectable full-scale
      Output Data Rate 500Hz

      2.0 Outputs


      16x Injector Outputs—high or low ohm.

      70V Clamping
      8A Peak, 4A hold, 10A Limit Injector Control
      Outputs can be used for ground switching , 6A Continuous , 10A Limit.
      All Outputs are short circuit and over current protected
      Independent Saturated or Peak & Hold control per channel
      No Flywheel diodes (external required for VVT control)
      12x Ignition Outputs.

      Adjustable TTL Ignition drive current (35mA or 70mA)
      Outputs can be used for ground switching, 1A Continuous, 3A Limit
      All Outputs are short circuit and over current protected
      No Flywheel diodes (external required for VVT control)
      16x Auxiliary Outputs

      Variable Valve Timing (VVTi) and Variable Valve Timing Electric (VTiE), Drive by Wire up to 4 Throttle Bodies, Dual Boost control, Gearshift Solenoids, Stepper motor and many more.
      All Outputs have PWM Control, maximum frequency = 15 kHz
      Flywheel diodes integrated into all outputs
      All Outputs are short circuit and over current protected
      Low Side Drivers

      Auxiliary 1-4: Low Side 4A continuous, 6A peak modulated, 8A Limit
      Auxiliary 5-8: Low Side 2.5A Continuous, 4A peak modulated, 5A Limit
      High Side Drivers

      Auxiliary 1-8: High Side 4A Continuous, 9A Limit
      Half Bridge Drivers

      Auxiliary 9-12: Half Bridge 5A Continuous and 8A limit. Can be used as Low Side, High side or together for DC motor control (DBW)
      Auxiliary 13-16: Half Bridge 7.5A Continuous(pin limited). Can be used as Low Side, High side or together for DC motor control (DBW)
      (NOTE: Auxiliary 9 -16 are used to control up to 4x DBW Throttle bodies)

      2x Wide Band Lambda LSU4.9 Heater control (onboard)

      Using Bosch Integrated circuit technology for sensor control, Nernst Cell temperature measurement and PID algorithm for precise heater control.
      1x Analog Output

      Voltage range 0 – 5.0V, Output current 100mA

      3.0 Inputs

      24x Analog voltage/temperature Inputs

      • Fully configurable including custom calibrations
      • Switchable pull-up resistors on ANV 7-12
      • Resolution is 1.22mV (12 Bit)

      8x Digital/speed Inputs

      • Frequency range from 0.0Hz up the 30kHz.
      • Wheel speed, VVT position and other frequency based signals.
      • On/Off switched inputs; air-con request, table control switching
      • Accepts a 0.0 – 20.0V analog input.
      • Switchable pull-up resistors on all 8 channels.

      6x Digital/Switched Inputs

      • On/Off switched inputs; air-con request, table control switching
      • Accepts a 0.0 -20.0 V analog input.
      • Switchable pull-up resistors on all 6 channels.

      2x Knock Inputs with configurable Frequency and Gain

      • Using Bosch, Digital Knock Integrated Circuit Technology
      • Selectable Frequency from 500Hz – 25kHz
      • Selectable Bandwidth from 100Hz – 5kHz
      • Selectable Digital Filter Window; Hamming or Blackman

      2x Wide Band Lambda LSU4.9 Sensors (onboard)

      • Using Bosch Integrated circuit technology for sensor control.
      • Lambda Range: 580 to open air.

      1x Dedicated Ignition Switch Input

      • 0 – 20.0V input used for EFI Relay Control

      4.0 Voltage Supplies


      4x ECU Supply Inputs

      6V – 22.0V Range
      Supplies ECU power
      Supplies Auxiliary 1-8 High Side Drivers
      Supplies Auxiliary 9 -16 Half bridge Drivers
      3x 5.0V Sensor Supply

      5V Vref1 Output Current 250mA
      5V Vref2 Output Current 250mA
      5V Vref3 Output Current 250mA
      1x 8.0V Sensor Supply

      Output Current 400mA
      1x ECU Constant Supply

      Internal ECU Hold Power Control

      5.0 Communications


      1 x High Speed Ethernet 100Mbps
      2 x CAN 2.0B 1Mbps/ 6 Channels per node

      6.0 Ordering Information


      Product Part Number
      Emtron KV16M ECU 112216213
      Emtron Ethernet Cable, Emtron Connector to Ethernet 1.5m 553-15

  • Reviews

  • Our Products

  • Product Details

    • Variant: Default Title
    • SKU: STP-MTRNKV16M
    • In Stock: 10
    • Weight: 2.5 kg
    • Product Type: Computer
    • Brand: Emtron

Join Our Mailing List

We are seeking to find out more of what you would like, send us a message with any special requests! Join Our Mailing List to receive updates when we stock more products!